|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
02-21-2020, 05:41 AM
|
#32 |
|
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 4,097
|
Re: How Ford Gauge Unit Work
And I have a question too - sorry!
Running 36 fuel tank, original sender, original dash unit, 12 volt conversion, [alternator], runtz on gas gauge, another on oil pressure gauge. Problem is that upon turning on ignition, needle in fuel gauge will climb and indicate [approximate] fuel level, but then when I start the engine and start driving, the needle goes down below empty and stays there. Why would this be?
__________________
Unfortunately, two half wits don't make a whole wit! |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:17 AM.