The Ford Barn

Stumann · 08-03-2019, 02:46 PM

Here are some pictures that I hope will explain what I'm talking about. The black metal part is the glass channel and the shiny metal part is the window regulator. The wheel of the regulator is not a very good fit in the channel. Is this normal?

john in illinois · 08-03-2019, 04:44 PM

It has been a while since I did mine and I thought it would only go in an end.
Mine was an original channel. Others with more knowledge may chime in.

I found this in Snyders catalog

Stumann · 08-04-2019, 06:19 AM

John, I think that might be the answer. If I an get that bottom part bent up to a 45 degree angle, it might fit into the groove of the regulator.

john in illinois · 08-04-2019, 04:29 PM

If that does not work out you could get a good original set from Bert’s model a store.

John

08-03-2019, 02:46 PM	#1
Stumann Junior Member Join Date: Jul 2019 Location: St. Louis, Mo. Posts: 10	Re: 30 'A' Sedan regulator to glass channel Here are some pictures that I hope will explain what I'm talking about. The black metal part is the glass channel and the shiny metal part is the window regulator. The wheel of the regulator is not a very good fit in the channel. Is this normal?

08-04-2019, 06:19 AM	#3
Stumann Junior Member Join Date: Jul 2019 Location: St. Louis, Mo. Posts: 10	Re: 30 'A' Sedan regulator to glass channel John, I think that might be the answer. If I an get that bottom part bent up to a 45 degree angle, it might fit into the groove of the regulator.

08-04-2019, 04:29 PM	#4
john in illinois Senior Member Join Date: May 2010 Location: Illinois Posts: 2,220	Re: 30 'A' Sedan regulator to glass channel If that does not work out you could get a good original set from Bert’s model a store. John __________________ Welcome each day