|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-26-2017, 06:33 AM
|
#10 |
|
Senior Member
Join Date: May 2010
Location: Auburn, MA
Posts: 2,106
|
Re: 8BA clutch finger adjustment
The hub is not a machined surface. Usually these things are set at the factory. I question whether .050 would make that much of a difference. Try loosening the clutch and reorienting it and see if you get the same measurements.
__________________
“The technique of infamy is to start two lies at once and get people arguing heatedly over which is true.” ~ Ezra Pound |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:37 AM.