Can not shift to 2nd or 3rd gear

[ccb360]

Hard or unable to shift into 2nd was resolved on my car by rebuilding shift tower. Not a hard job. Problem was 2nd/3rd shifter fork square slot was worn noticeably. That plus shifter ball wear would not allow proper shift.

[RonC]

Originally Posted by Rick6

Keith,

Several posts back it was suggested that I check the clutch acuator arm for cracks leading to a loos in movement. You can not see the acuator on the inside of the bell housing from the bell housing inspection access window where you grease the throw-out bearing.

Yes, I did grease the throw-out bearing.

The arm is on the outside. The arm is where you adjust the free play to 1"