Looking for a Particular T5 Thread

[TomT/Williamsburg]

A long day today, talking to many people about my problem after the long weekend. The result is that I am going to shave down my T5 adapter and what ever I get out of that is what I get - looks like a minimum of 1/4", maybe even up to 3/8". This was suggested by Russell Martin, the nail head guru I have ordered my parts from.

I ordered a McLeod clutch disk, 673-260130, so I can mock everything up, make my measurements, and know how much to shave off. I will also check my t-out bearing clearances and see if I need to shave the stock t-out bearing holder ....

Minimum I am hoping for is 3/4" of a byte - I would be ecstatic with 7/8-1". We shall see .....