Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 12-26-2010, 08:45 PM   #1
glenn in camino
Senior Member
 
glenn in camino's Avatar
 
Join Date: May 2010
Location: Camino, CA.
Posts: 3,086
Default Re: Model A Garage & Heat???

Forgive me for bragging, but in the process of building my Model A garage, I bought a radiant heating system from Radiantek.com in Vermont. They shipped it to me and my contractor and I installed it before the floor was poured. It's heated by a high efficiency water heater powered by propane. The tank is outside. It stays 65 degrees in my garage 24/7, even when it's in the 20s outside, with no fan blowing air and dust and with no flames or noise. I wish I had it in my house. I highly recommend radiant heat for any new building.
glenn in camino is offline   Reply With Quote
Old 12-26-2010, 09:30 PM   #2
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,972
Default Re: Model A Garage & Heat???

Quote:
Originally Posted by glenn in camino View Post
Forgive me for bragging, but in the process of building my Model A garage, I bought a radiant heating system from Radiantek.com in Vermont. They shipped it to me and my contractor and I installed it before the floor was poured. It's heated by a high efficiency water heater powered by propane. The tank is outside. It stays 65 degrees in my garage 24/7, even when it's in the 20s outside, with no fan blowing air and dust and with no flames or noise. I wish I had it in my house. I highly recommend radiant heat for any new building.
Glenn, what do you expect your water heater is using per month in propane? Does the burner cycle on quite a bit as it is circulating or does the water make several cycles through the floor before the burner has to reheat the water? Do you expect fuel consumption is about the same as what your house water heater uses?

.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 12-26-2010, 09:52 PM   #3
IrishHills
Senior Member
 
IrishHills's Avatar
 
Join Date: Sep 2010
Location: Brooklyn, Michigan "Home of M.I.S."
Posts: 399
Default Re: Model A Garage & Heat???

Probally not the best but I use a 6' 1910 Round Oak wood stove, 30 x 40 pole barn 10' ceiling, built out of cedar no insulation at all, work in a T shirt on coldest days.

Keep in mind propane is lighter than air, Very Dangerous!!!

Edit: meant to say heavier than air... thanks Guys

Last edited by IrishHills; 12-27-2010 at 09:08 AM.
IrishHills is offline   Reply With Quote
Old 12-27-2010, 02:53 AM   #4
Mustang
Member
 
Mustang's Avatar
 
Join Date: May 2010
Location: Alberta, Canada
Posts: 63
Default Re: Model A Garage & Heat???

Keep in mind propane is lighter than air, Very Dangerous!!![/QUOTE]


Sorry – The real (or perceived) danger of propane
is because it is heavier than air, and tends to pool
at floor level rather than dissipate into the air.
It also has 2.5 times the BTU content per cu ft vapour
compared to natural gas, so a bigger boom for your buck.

For those with high ceilings, a hardware store plain Jane
‘reversible’ ceiling fan at ceiling level, blowing upwards
in the heating season forces the warm air trapped at the
ceiling to flow across to and down the walls, giving
better efficiency and comfort with most heating systems.

Regards
Art

Last edited by Mustang; 12-27-2010 at 03:01 AM.
Mustang is offline   Reply With Quote
Old 12-27-2010, 03:03 AM   #5
sturgis 39
Senior Member
 
Join Date: Aug 2010
Location: Lead. South Dakota
Posts: 963
Default Re: Model A Garage & Heat???

Quote:
Originally Posted by IrishHills View Post
Probally not the best but I use a 6' 1910 Round Oak wood stove, 30 x 40 pole barn 10' ceiling, built out of cedar no insulation at all, work in a T shirt on coldest days.

Keep in mind propane is lighter than air, Very Dangerous!!!
I think you have it backwards. Propane is heavier than air.
__________________
IF IT CAN NOT BE FIXED WITH BLASTING WIRE, JB WELD OR DUCT TAPE ---IT CAN NOT BE FIXED

Do not get me started on the stupidity of ethanol. I think one of the monitors is from Iowa and he will delete the thread.
sturgis 39 is offline   Reply With Quote
Old 12-27-2010, 03:32 AM   #6
sturgis 39
Senior Member
 
Join Date: Aug 2010
Location: Lead. South Dakota
Posts: 963
Default Re: Model A Garage & Heat???

Sponsored Links (Register now to hide all advertisements)
I heat my shop with propane. electric and wood stove. It is 16'x20' and insulated. The propane is an infrared heater with two burners feed with a seven pound bottle. I turn it on while getting the wood stove going. I have installed a carbon monoxide monitor. The electric heater is 240 volt wall mount unit that I plug into my welding outlet. I do not use it much.

I went to a stove place the other day. I wanted to buy a pellet stove. The guy said propane was half the price of pellet stoves (dollars per BTU). I went to Menards and they have propane heaters for garages that do not have to be vented. They have oxygen sensers but they will not operate above 4500' elevation very well. They are wall mounted and about 9"x3'x4'. They tell what size for a one to three car garage. My elevation is 5600 feet so I will probably not buy one.

I think I will buy a good wood/coal stove and and throw a lump of coal in for the night. My wood stove is getting to in bad shape.
__________________
IF IT CAN NOT BE FIXED WITH BLASTING WIRE, JB WELD OR DUCT TAPE ---IT CAN NOT BE FIXED

Do not get me started on the stupidity of ethanol. I think one of the monitors is from Iowa and he will delete the thread.

Last edited by sturgis 39; 12-27-2010 at 03:40 AM.
sturgis 39 is offline   Reply With Quote
Old 12-27-2010, 11:03 AM   #7
glenn in camino
Senior Member
 
glenn in camino's Avatar
 
Join Date: May 2010
Location: Camino, CA.
Posts: 3,086
Default Re: Model A Garage & Heat???

Quote:
Originally Posted by BRENT in 10-uh-C View Post
Glenn, what do you expect your water heater is using per month in propane? Does the burner cycle on quite a bit as it is circulating or does the water make several cycles through the floor before the burner has to reheat the water? Do you expect fuel consumption is about the same as what your house water heater uses?

.
The system runs now and then during the day depending on the outside temp and is on a thermostat for each room. My garage has 3 rooms that I can control individually. I don't keep track of the propane use.
glenn in camino is offline   Reply With Quote
Old 12-27-2010, 05:07 PM   #8
Jerry Parr WI
Senior Member
 
Jerry Parr WI's Avatar
 
Join Date: May 2010
Posts: 619
Default Re: Model A Garage & Heat???

Quote:
Originally Posted by glenn in camino View Post
Forgive me for bragging, but in the process of building my Model A garage, I bought a radiant heating system from Radiantek.com in Vermont. They shipped it to me and my contractor and I installed it before the floor was poured. It's heated by a high efficiency water heater powered by propane. The tank is outside. It stays 65 degrees in my garage 24/7, even when it's in the 20s outside, with no fan blowing air and dust and with no flames or noise. I wish I had it in my house. I highly recommend radiant heat for any new building.
I agree in floor radiant heat is the best way to go. My brother did it with his garage and his house. Difficult to retrofit but the next time I break up the concrete in my garage floor I will install it.

When it's in the 20s here we call that a heat wave and people shed their winter coats.
Jerry Parr WI is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:10 AM.