|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-18-2016, 04:16 PM | #1 |
Junior Member
Join Date: Feb 2015
Location: Rosseau. Ontario
Posts: 16
|
Is this 59A flathead part available?
I own a 1940 Ford tudor with a C59A motor.
On the Clutch side of the block, there is a “cup” that accepts the starter shaft as it engages the flywheel. Is this “cup” available as a separate part? Mine has been worn through in the area closest to the ground (likely from too many unpaved Canadian roads). No parts catalogue I've seen shows it as a separate part. Bob Drake's response was that it is not available as a replacement. Do I need to find a dead block and remove it, (unlikely since the availability of parts here is pretty slim), or has someone out there have one that they smartly knocked out as insurance? |
02-18-2016, 04:18 PM | #2 |
Member Emeritus
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
|
Re: Is this 59A flathead part available?
Not part of the block, it is part of the Oil pan. Some people fab them, but you should be able to find one.
|
Sponsored Links (Register now to hide all advertisements) |
|
02-18-2016, 07:00 PM | #3 |
Senior Member
Join Date: May 2013
Location: Coos Bay, OR
Posts: 641
|
Re: Is this 59A flathead part available?
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|