|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-22-2015, 06:57 PM
|
#8 |
|
Senior Member
Join Date: Nov 2011
Location: Connecticut
Posts: 204
|
Re: Intake/Exhaust Manifold lug thickness
Seems to me that if the surfaces on both manifolds are flat and smooth on the side that matches up to block, and you torqued the manifolds down using the cupped washers and nuts, that they would seal tightly against the block. Then bolt the 2 manifolds together.
Does that make sense, or am I missing something ? Tommy- |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:16 PM.