|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-23-2015, 01:45 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Portland, Oregon
Posts: 6,039
|
How do I measure a cylinder?
I want to determine whether the cylinders in one of my extra blocks are worn, out-of-round, or tapered. How does an amateur garage mechanic do this (what is the correct tool), and what are the acceptable tolerances before a rebore or sleeves are needed?
__________________
Ray Horton, Portland, OR As you go through life, keep your eye on the donut, not the hole. 
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:49 PM.