Has Anyone Installed A Quietride Acoustishield Insulation Kit?

[Lembomw]

Has anyone installed one of Quietride Solution’s Acoustishield pre-cut noise and heat insulation kits in their Tudor. I have a ’30 Tudor.

I purchased the kit for the whole car and everything is going in nicely. The pre-cuts are great, very little trimming needed.

My question is the roof. My car is completely apart and I have installed all new wood for the top. Is the acoustishield insulation mat for the top suppose to be used in place of the cotton wadding, or do I just lay it on top of the chicken wire then put the cotton wadding on top of the insulation then the vinyl? Seems like if I did that it would be too thick.

The insulation mat supplied is one piece 40 inches wide by 71 inches long which would bring it right to the inside edges of all the wood supports around the top, but not up to the metal part of the roof which is where the wadding would go and be nailed . If I measure the opening where I believe the chicken wire and cotton wadding goes (I have not done this before but will be following the instructions and pictures I found on the Model A Ford Barnyard site) it is 42 inches wide by 73 inches long . Before I go back to Quietride Solutions I want to make sure of the process from someone who has already done it.

Thanks, Mark