Leaf spring bushings for '49 custom

[CJStefan]

So I just went to install my new bushings into my Jamco 4" drop leaf Springs and they're waaaaay too small. I know a ton of people run their springs (i tried them in my original springs and it's the same thing) so what are you guys doing to make them work? I figure i have a 1/1000 chance of finding a set of NOS bushings. I just want to get this car on all 4 tires and it seems like every time I think I have a chance something else goes wrong haha

[tubman]

It sounds like you have the wrong bushings. "Shoebox Central" has them for $1.95. I doubt that they carry the wrong ones.

[CJStefan]

That's where I got them

[Shoebox]

Originally Posted by CJStefan

That's where I got them

Guess I'd give the boys at Shoebox Central a call.

[34PKUP]

Originally Posted by CJStefan

So I just went to install my new bushings into my Jamco 4" drop leaf Springs and they're waaaaay too small. I know a ton of people run their springs (i tried them in my original springs and it's the same thing) so what are you guys doing to make them work? I figure i have a 1/1000 chance of finding a set of NOS bushings. I just want to get this car on all 4 tires and it seems like every time I think I have a chance something else goes wrong haha

Define waaaaay too small using what you have as measurements.
Seem to recall having to press them in.

[CJStefan]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by 34PKUP

Define waaaaay too small using what you have as measurements.
Seem to recall having to press them in.

Let me see if I can upload a pic

[CJStefan]

How do I post a pic on here?

[CJStefan]

I can't figure out how to post a picture on here but I'll post one over on the hamb

[CJStefan]

https://www.jalopyjournal.com/forum/...#post-14414348

[5851a]

Sounds as though you received a rear shackle bushing and not a front bushing.

[CJStefan]

They're not the same bushings on both ends? The eyes are all the same size on the new springs and the old springs

[5851a]

I am probably wrong and thinking of later with larger front eye. I was thinking of the type that has inner and outer metal sleeve that needs to be installed with a press. They were on the front of spring only.

[CJStefan]

These are just the two rubber halves with no center sleeve. It's really a terrible design

[Tinker]

I've run poly-nylon spring bushings before. Worked well. Been a bit but I can't remember them running the full 2" of the spring. Could be wrong...

[CJStefan]

Originally Posted by Tinker

I've run poly-nylon spring bushings before. Worked well. Been a bit but I can't remember them running the full 2" of the spring. Could be wrong...

You mean the poly bushings the vendors sell instead of rubber? I'd definitely run those if they'll work.

[Tinker]

Ordered a front stabilizer bar for my old 53 from fatman fab. No mention you have to cut up your grill valiance. Most everything else worked from them.

Nothing is more frustrating then a dead line and nothing works.


.

[Tinker]

I checked out you hamb post.

Seems to be a lot of slop in the rubber bushings to your leaf spring eyes.

I'd trust the poly's over rubber everytime, over time. No comment on fit.


.