A question on Les Andrews's ring specs - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
A question on Les Andrews's ring specs

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

11-14-2014, 01:20 PM	#1
700rpm Senior Member Join Date: May 2010 Location: Portland, Oregon Posts: 6,039	UPDATE A question on Les Andrews's ring specs Les specifies ring gaps as .012-.015 for top; .010-.012 for middle. .008-.010 for bottom. Tbirdtbird specifies .022 top; .-016-.018 for middle. I used Les's when I put my engine together. I didn't have Tbird's specs at that time. The engine seems pretty tight when it's warmed up. Now I'm wondering if I should tear it down and reset the gap. These are significantly different. Can anyone explain that? See 5/21/15 followup below. __________________ Ray Horton, Portland, OR As you go through life, keep your eye on the donut, not the hole. Last edited by 700rpm; 05-23-2015 at 06:54 PM. Reason: Followup to original thread

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 10:09 PM.