New block machining. - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
New block machining.

Sponsored Links (Register now to hide all advertisements)

11-03-2014, 06:25 PM

#13

Crazydaddyo

Senior Member

Join Date: May 2010

Location: Orange, Ca.

Posts: 197

Re: New block machining.

Quote:

Originally Posted by Pete

Just speculating but if SCAT were to make a model A/B crank it would most likely be cast like their flathead V8 cranks are. It's a cost thing.

Scat makes a crank for the 3 main A/B engine now. It is forged.

http://www.scatcrankshafts.com/#1

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 11:02 AM.