|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
10-10-2014, 05:49 AM
|
#1 |
|
Junior Member
Join Date: Mar 2012
Location: Dearborn Hts, MI
Posts: 11
|
New bearing shim packs
Hello, I'm sure you all have been through this at one time?
Is there an easy way to peel shims off without messing up the whole pack? Thanks a bunch... |
|
|
|
10-10-2014, 09:39 AM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Rhode Island
Posts: 1,868
|
Re: New bearing shim packs
Slightly heat them with a propane / map gas torch. They will fall apart. Don't overheat and melt them
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
10-10-2014, 11:07 AM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 6,370
|
Re: New bearing shim packs
I use a razor blade, seems to work ok.
|
|
|
|
|
10-11-2014, 10:15 PM
|
#4 |
|
Junior Member
Join Date: Mar 2012
Location: Dearborn Hts, MI
Posts: 11
|
Re: Bent rear axle -'25 T Coupe
Looks like I may have a bent axle shaft. The rear wheel has a 5/8" wobble underway. I tried switching wheels from the other side and the runout persists. My question is. Has anyone ever straightened an axle without removing the rear end and changing it? Like removing the wheel and prying the end of the shaft while checking runout with a dial indicater. May not be Kosher but very curious.
|
|
|
|
|
10-14-2014, 07:55 PM
|
#5 |
|
Junior Member
Join Date: Mar 2012
Location: Dearborn Hts, MI
Posts: 11
|
Re: New bearing shim packs
Sponsored Links (Register now to hide all advertisements)
Thanks... |
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:30 AM.