|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-14-2023, 10:42 AM
|
#7 |
|
Senior Member
Join Date: May 2010
Location: Southern California
Posts: 3,168
|
Re: Clutch cover question.
When you have a Model A flywheel re-surfaced you should take the same amount of material off the ridge where the pressure plate bolts up. The original dimension between the clutch surface and the ridge is 1.123". That dimension should be restored to be able to adjust the fingers properly.
Tom Endy |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:55 AM.