|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-23-2016, 05:45 AM
|
#11 |
|
Member Emeritus
Join Date: May 2010
Location: Fitzgerald, Georgia
Posts: 2,204
|
Re: Could Edelbrock cast a flathead block
The Kirby aluminum Flathead block was not like our Ford blocks except it was a Flathead. Making a Flathead block would be a VERY difficult (expensive) project for ANY company. It would only be easy on television.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:55 AM.