The Ford Barn

jeepguy1948 · 08-20-2024, 11:12 PM

I made the mistake of posting about this in the For Sale section so I’ll start over here. I need a Pitman arm that clamps on to a square sector shaft (like a Model A uses), is the length of a ‘32 arm, and has a hole in it instead of a permanently attached ball. I could cut up a shortened Model A arm, drill, and taper a hole but I would prefer not to cut up a good one. I don’t know if this is an item that would be “stock” for later (later than a Model A) car/truck or if it would be a custom item. I would like some help figuring out what I actually need and where I can buy one. If somebody has one to sell that would be cool too.

08-20-2024, 11:12 PM	#1
jeepguy1948 Senior Member Join Date: Jan 2022 Posts: 889	Pitman Arm? I made the mistake of posting about this in the For Sale section so I’ll start over here. I need a Pitman arm that clamps on to a square sector shaft (like a Model A uses), is the length of a ‘32 arm, and has a hole in it instead of a permanently attached ball. I could cut up a shortened Model A arm, drill, and taper a hole but I would prefer not to cut up a good one. I don’t know if this is an item that would be “stock” for later (later than a Model A) car/truck or if it would be a custom item. I would like some help figuring out what I actually need and where I can buy one. If somebody has one to sell that would be cool too.