|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-09-2016, 07:38 PM
|
#23 |
|
Senior Member
Join Date: Nov 2013
Location: Prescott, AZ
Posts: 585
|
Re: Found a crack in the block
Test pressure was 5 PSI. Bubbles showed up when sprayed with Windex.
Fusion welding is out. Contacted Lock-n-stitch. They said the sleeve MIGHT work but wasn't anything they could do and said they couldn't offer any kind of solution. Not going to attempt to braze or weld it. I agree with Ronnie. A two to three hundred dollar block would be a better than paying that much for a sleeve if I could get it done for that. Thanks everyone.
__________________
Nothing wrong with it except for the name on the front. Alex |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:25 PM.