|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
10-21-2015, 02:12 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Manawatu, New Zealand
Posts: 1,420
|
Unusual Helmet Coil
Recently I obtained a NORS helmet coil for my 1934. It fits perfectly on my 3 hole distributor but it arrived minus a coil brush and spring. When I go to install the correct brush and spring I find that the hole for thisin the coil is way to small -Not only will the spring not fit in there but even the brush is to fat . Not sure what is going on I suspect I will need to drill out the hole so I can install the brush - Any ideas what I have -Karl
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:32 PM.