Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-11-2015, 05:23 PM   #25
barkleydave
Senior Member
 
barkleydave's Avatar
 
Join Date: Oct 2014
Location: Kentucky
Posts: 502
Default Re: Installation of Temp Gauge

Ok weather improving.... took truck out for a short run. (3 miles or so) Outside temp 63 degrees. Ran well had mixture 1/2 open. Ran 40 mph for a mile then pulled into a large parking lot and ran slowing for about 5 min. Gauge was reading just above 165 or so. Headed back on HWY and temp continued to climb to the upper limit of the green. No steam... no overflow no leaks... check radiator fluid temp 10 min. after sitting with a real temp gauge (long stem scientific) Was at 160+ Pegged meter.

Truck has new radiator.. new water pump and fresh antifreeze.

Question: is this normal temp ?

Before I put in the gauge I ran the truck 50 miles at 45 mph and the moto meter never moved. No overheat or loss of fluid.

I am guessing it was running around 180 degrees.

Opinions welcome
barkleydave is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:02 AM.