|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
02-24-2015, 08:52 PM
|
#1 |
|
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Deck (trunk) Lid Hinge Bracket...
On the Deck (trunk) Lid there are two brackets, both on the upper corners, left and right, and inside the lid.
The two brackets are connected to the lid by the means of a flat head rivet (YES DUDLEY...IT IS A RIVET AS YOU WELL KNOW). The question is, was this a solid fit by the rivet OR was there supposed to be some slight movement of the brackets for means of adjusting the lid squareness? Thank you. Pluck Last edited by Steve Plucker; 02-24-2015 at 09:32 PM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:58 PM.