|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
03-08-2017, 09:37 AM
|
#1 |
|
Senior Member
Join Date: Aug 2016
Posts: 168
|
Steering column question
shouldn't the lower bearing housing be flush?
|
|
|
|
03-08-2017, 09:53 AM
|
#2 |
|
Senior Member
Join Date: Aug 2016
Posts: 168
|
Re: Steering column question
http://www.snydersantiqueauto.com/Co...link--3688.pdf
also how does part 34Light rob felt seal go on? The seal I have only has like a .125" dia. hole in it? |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
03-08-2017, 12:22 PM
|
#3 |
|
Senior Member
Join Date: Aug 2016
Posts: 168
|
Re: Steering column question
ok So I got the column together and in I have not put the pitman arm on the sector shaft yet but I slide the steering wheel on and its very hard to turn. Any idea of what I have done wrong?
|
|
|
|
|
03-08-2017, 12:31 PM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Steering column question
Do you have the square brass shims in the end plate? You may have to add a few to give it more clearance. You want the clearance to just be at zero without binding the bearings.
|
|
|
|
|
03-08-2017, 01:02 PM
|
#5 |
|
Senior Member
Join Date: Aug 2016
Posts: 168
|
Re: Steering column question
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:35 AM.