In need of the following photos for a project...

[Steve Plucker]

I am in need of the folowing photos for a project I am doing:

1. The early engine pad with stamping;

2. The 2" pad with stamping;

3. The 2-1/2 inch pad with stamping;

No restamp pads on 1-3.

Also, please put a ruler on the bottom of the pad to indicate the length.

4. A engine pad that HAS BEEN RESTAMPED showing the ground off number (if there) and the new restamp number;

5. Assembly plant codes and numbers;

6. The rear frame crossmember showing the rear spring codes;

If you can provide me with a few of these it would be most appreciated.

Please direct email me at [email protected]

Thanks.

Pluck