|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
08-27-2015, 06:21 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: South California
Posts: 6,190
|
distributor drive shaft/tang slot
Anyone know how far off center (of 1/2" shaft)that the slot AND tang is cut.
Trying to figure out mechanics of refitting a magneto TANG to shaft slot. |
|
|
|
08-27-2015, 09:34 PM
|
#2 |
|
Senior Member
Join Date: Apr 2015
Location: Boise, Idaho
Posts: 1,607
|
Re: distributor drive shaft/tang slot
I measured this old shaft...it's as accurate as I can get it..the caliper is all I have for this sort of stuff.....
__________________
Early '29 CCPU that had a 4-speed, but not any more.......in the family since '62 |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
08-28-2015, 12:39 PM
|
#3 | |
|
Senior Member
Join Date: May 2010
Location: South California
Posts: 6,190
|
Re: distributor drive shaft/tang slot
Sponsored Links (Register now to hide all advertisements)
Quote:
 !I will use these numbers to do further research. I'm wondering is Ford had a 'drawing' of what an original shaft measured...as to outside diam and slot tang. |
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 10:05 AM.