|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Feb 2011
Posts: 154
|
![]()
Have heard about the Sheridan OverDrive Transmissions that are modified to be used in Model A's. I would like to hear from actual users as to their
ease of installation, satisfaction with performance, speed increase, etc. if possible before perhaps going that route. Many thanks! |
![]() |
![]() |
![]() |
#2 |
Member
Join Date: Jun 2010
Location: Michigan
Posts: 59
|
![]()
I have one in my 31 tudor. We have put about 15,000 miles on the car with the setup.
Sheridan's use the same top loading over drive F150/Bronco transmission that others do that I have read about in this forum. I know Tim Sheridan is busy making and selling several setup per month. This is what I remember about the setup. It comes with a top loading transmission adapted to bolt up to the Model A bell housing. The drive shaft Torque tube and radius pods are shortened. It also comes with a lightened flywheel with V-8 Pressure plate. Everything is just a bolt in. About half of our Local club have Tim's setup in their cars. In overdrive my top end was not any faster because I ran out of power, that is until I installed a hi compression head. Then I could go faster than I wanted to travel. Cal |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: Feb 2011
Posts: 154
|
![]()
Thanks Cal for your information. Was there a reason why you went with the Sheridan set up rather than going with the Mitchell modified A transmission with synchro gears and 15% higher gearing?
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Nov 2010
Location: Anchorage, Alaska
Posts: 9,192
|
![]()
The Mitchell transmission is the same in 3rd gear as the stock Model A -- 1:1, no overdrive. Mitchel's overdrive is a separate unit.
|
![]() |
![]() |
![]() |
#5 |
Member
Join Date: May 2010
Posts: 67
|
![]()
modelaonly.com bolt in kit
|
![]() |
![]() |
![]() |
#6 |
Member
Join Date: Jun 2010
Location: Michigan
Posts: 59
|
![]() Sponsored Links (Register now to hide all advertisements)
he said he is getting $1495 at the present if he supplies everything. Tim's number is 616-837-6477. Cal |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|