JB Weld on crank end housing? - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
JB Weld on crank end housing?

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

Old

01-06-2014, 02:02 AM

#1

Rubatoguy

Member

Join Date: Mar 2012

Location: Oregon City

Posts: 47

Default

JB Weld on crank end housing?

I pulled the flywheel on my model A engine and found this - It looks like the rebuilder used JB Weld to form half of the end of the crank end bearing housing. Is this done very often and an accepted repair?

Todd

Attached Images

jbweld at crank end sm.jpg (68.3 KB, 645 views)

Rubatoguy is offline

Reply With Quote

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 01:00 AM.