|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Member
Join Date: Aug 2010
Posts: 70
|
![]()
found a pair of c heads wondering what one of them may be may be worth
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Southern California
Posts: 7,305
|
![]()
I assume you mean the heads with the "C" cast in. They are probably going to be hard to sell and not worth very much ($40 unless they are NOS and then maybe a little more). You need to find someone restoring a 1932-34 Ford four cylinder Ford and most of those guys will already have a few extra heads setting around. You should post your question in the Early V8 section since the heads were used in those years.
Charlie Stephens |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 8,099
|
![]()
This comes up often. I just looked at the Piranio antique automotive dyno sheet and it shows a 6.77 horsepower increase at 2200 RPM. This is a stock model A engine with no other modification than the change to the C head. The three bolt water pump cools much better than the model a water pump. A lot of people feel that its not worth the bother. Personaly, I can feel the 6.77 horsepower increase. I can also appreciate the advantage of the three bolt water pump.
These heads usually go for less than one hundred bucks. If a person didn't want to pay the price of a new higher compression head but needed to gain some more power, a good C head with a rebuildable water pump core could be a good thing. You could pick up a few more horses by adding a B carb and reamed out model A intake manifold. |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Nov 2011
Location: B.C. Canada
Posts: 1,746
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|