1936 sedan front springs

[Ohc Joe]

Anyone in Southern California have a lowered front spring setup for sale by chance 36 Ford Sedan stock setup before I try to put these shackle bushings in here I wouldn't mind lowering it two to four inches or so or where can I buy one thanks guys

[TJ]

I would not go the "Mono Leaf" route. I saw a couple of them break. Try Pete and Jakes or Posies. Both may have a reversed eye main leaf. As an alternative you could take the stock spring to a good spring shop and have them de-arch the spring.

[Ohc Joe]

Ok sounds good I'll look those guys up rather just get a complete unit ready to install if I can

[40cpe]

https://www.speedwaymotors.com/Posie...-Drop,841.html

A posie spring might not give a 2" drop compared to the old, sagging spring.

[Ohc Joe]

Originally Posted by 40cpe

https://www.speedwaymotors.com/Posie...-Drop,841.html

A posie spring might not give a 2" drop compared to the old, sagging spring.

Awesome thanks the shake bushings need to be pressed in i assume on these bad boys

[rich b]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by Ohc Joe

Awesome thanks the shake bushings need to be pressed in i assume on these bad boys

If the pin in the spring eye on the wishbone is good and you prefer stock style shackles a stock pin will work in an aftermarket spring.

We usually use modern shackles with poly bushings as the original stuff is worn out. Easier too; than dealing with oversize repop pins.

[Ohc Joe]

The pin was completely worn out
Found a lower reverse new spring
It's on the way
How do these shakles install
Just a press I assume
Got a set from shoot the guy in LA Verne california awhile back ago the shakles kit
Ford store maybe

[TJ]

If it were me I would use the later type nylon bushing kit for the shackles. Much easier to install.