|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Dec 2013
Location: Corsicana, Texas
Posts: 1,306
|
![]()
I just recently purchased a 1930 Deluxe Roadster and noticed that it didn't have a wiper motor. The wooden header above the windshield looks like it is notched and has provisions for 2 motors. I don't see anything listed by any of the vendors for such an animal. If you have the correct setup on your car, could you post some photos? Appreciate it very much!!
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Feb 2019
Location: Erie Pa
Posts: 961
|
![]()
Hello, the header is made like that to accept a wiper on either side, depending if it is right or left hand drive. Most of the Roadsters I have seen have a Trico vacuum wiper, chrome plate on deluxe.This would be the 1930 -31 models. Repro are available.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: Oct 2020
Location: Oregon City, OR
Posts: 125
|
![]()
According to Model A Judging Standards publication by MAFCA, 1930 open models used Owen-Dyneto electric wiper motors up to June 1930 then switched to Trico vacuum wiper motors. Pictured motors were those used on open models.
Last edited by 40-A Twins; 06-30-2022 at 01:34 AM. Reason: edit |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Apr 2014
Location: Montpelier, VT
Posts: 223
|
![]() |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Location: Epping N.H.
Posts: 3,421
|
![]()
The DeLuxe was introduced in August of 30,so the electric wouldn't apply to one of those.I had a June of 30 standard with 28000 miles on it,and was an unmolested car.That car had a vacuum wiper,and had all the original piping,with all the original clips in place.I didn't know repros were being made again.
|
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Dec 2013
Location: Corsicana, Texas
Posts: 1,306
|
![]() Sponsored Links (Register now to hide all advertisements)
Your photo is exactly what I was looking for. My car has a wire running up to where there should be a wiper motor, but my car didn't have one, so I didn't know how the motor was attached to the car. I now see that they used a motor that clamped onto the upper windshield frame as shown in your photo. Guess I'll be trying to track one down. Thanks again! |
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,712
|
![]()
In the photo it looks like the motor is just fastened to the clamps.
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|