The Ford Barn

Seattledavid · 04-19-2020, 06:18 PM

I have a 1930 sport coupe with hydraulic brakes and I believe it has a 1939 backing plate. There is a gasket on the rear hub that I have not been able to find from any of the vendors so don’t know if it is necessary. The first photo I attached shows it in its normal position and the second photo I moved it up so you can see it better. Does anyone know if they are available or if they are needed??

Dave

BillLee/Chandler, TX · 04-19-2020, 07:16 PM

Gasket? It looks a lot like the inner race of the inner wheel bearing.

Seattledavid · 04-19-2020, 07:23 PM

Wasn’t sure what to call it. The back is metal with rubber attached to it.

Charlie Stephens · 04-19-2020, 08:27 PM

That might be an extra seal that was added because the seal inside of the axle housing was leaking.

Charlie Stephens

Bbhf · 04-27-2020, 02:48 PM

Sponsored Links (Register now to hide all advertisements)

Dave: there a only two seals on the axle side: one is in the hub that holds the grease in behind the roller bearing and that has a snap ring to hold it in place: the other is behind the axle nut washer to seal outer end of the axle: look at any parts diagram for the rear hub assembly: i do not believe that part belongs there: better check all axles to make sure they are put together correctly: hope this helps: sk

04-19-2020, 07:16 PM	#2
BillLee/Chandler, TX Senior Member Join Date: May 2010 Location: The sticks of east Texas Posts: 474	Re: 1930 Sport coupe with hydraulic brakes Gasket? It looks a lot like the inner race of the inner wheel bearing. __________________ Bill Lee http://www.CedarCreekAs.org

04-19-2020, 07:23 PM	#3
Seattledavid Member Join Date: Apr 2020 Posts: 32	Re: 1930 Sport coupe with hydraulic brakes Wasn’t sure what to call it. The back is metal with rubber attached to it.

04-19-2020, 08:27 PM	#4
Charlie Stephens Senior Member Join Date: May 2010 Location: Southern California Posts: 7,305	Re: 1930 Sport coupe with hydraulic brakes That might be an extra seal that was added because the seal inside of the axle housing was leaking. Charlie Stephens

04-27-2020, 02:48 PM	#5
Bbhf Member Join Date: Aug 2012 Location: CT Posts: 49	Re: 1930 Sport coupe with hydraulic brakes Sponsored Links (Register now to hide all advertisements) Dave: there a only two seals on the axle side: one is in the hub that holds the grease in behind the roller bearing and that has a snap ring to hold it in place: the other is behind the axle nut washer to seal outer end of the axle: look at any parts diagram for the rear hub assembly: i do not believe that part belongs there: better check all axles to make sure they are put together correctly: hope this helps: sk Last edited by Bbhf; 04-27-2020 at 03:03 PM.