The Ford Barn

BillCNC · 01-05-2018, 02:20 PM

Hey Guy's,

I pulled these out of my rear brakes a while back and forgot to post this earlier. They are quite different from the front's or the replacement's from the part houses.

Any clue as to what the reason was for the two part assembly, and who make them?

Regards
Bill

jw hash · 01-05-2018, 02:26 PM

they look to be part of Flat Head Ted`s brake floating set up. there should a jam nut on the out side.

BillCNC · 01-05-2018, 02:51 PM

Sponsored Links (Register now to hide all advertisements)

Thanks a bunch jw.

It does have Flat-Head-Ted Setup's on the rears but no jam nut's were on the car and were just screwed in like the stock wedges.

Are they better than the stock ones? I do have an extra set to replace them with if they are inferior.

Regards
Bill

01-05-2018, 02:26 PM	#2
jw hash Senior Member Join Date: May 2010 Location: Auburn Washington Posts: 2,662	Re: Help with Brake Wedge ID they look to be part of Flat Head Ted`s brake floating set up. there should a jam nut on the out side.

01-05-2018, 02:51 PM	#3
BillCNC Senior Member Join Date: Aug 2017 Location: SoCal Desert Posts: 842	Re: Help with Brake Wedge ID Sponsored Links (Register now to hide all advertisements) Thanks a bunch jw. It does have Flat-Head-Ted Setup's on the rears but no jam nut's were on the car and were just screwed in like the stock wedges. Are they better than the stock ones? I do have an extra set to replace them with if they are inferior. Regards Bill