Galvanizing a Brass Screw - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
Galvanizing a Brass Screw

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

11-12-2021, 01:31 PM	#1
BRENT in 10-uh-C Senior Member Join Date: May 2010 Location: Eastern Tennessee Posts: 11,971	Galvanizing a Brass Screw I know this is random, but I am struggling to find a #10 oval headed steel screw, -however I can find all sizes & lengths in Brass. Does anyone have any experience in some type of coating that I can use on Brass to replicate a Cold Galvanized look? Maybe the same Galvanized look onto Stainless screws?? __________________ . BRENT in 10-uh-C . www.model-a-ford.com ...(...Finally Updated!! ) .

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 09:44 AM.