The Ford Barn

junkyardjeff · 02-23-2018, 10:08 PM

My 66 originally came with a 352 and truck 4 speed and I had put a new clutch in it a couple thousand miles at the most before it got a 460/C-6,now its going to get a 351-W and 3 speed and would like to reuse the clutch parts since they have no miles on them. Its a diaphram PP and it looks like the fingers stick out further then usual,the 4 speed trans had a longer input shaft and deeper bellhousing so anyone know if the PP is different for the 4 speed then with a 3 speed and I do not have another to compare it too and according to one parts stores website there is no difference.

02-23-2018, 10:08 PM	#1
junkyardjeff Senior Member Join Date: May 2010 Location: dayton Ohio Posts: 243	66 truck pressure plate My 66 originally came with a 352 and truck 4 speed and I had put a new clutch in it a couple thousand miles at the most before it got a 460/C-6,now its going to get a 351-W and 3 speed and would like to reuse the clutch parts since they have no miles on them. Its a diaphram PP and it looks like the fingers stick out further then usual,the 4 speed trans had a longer input shaft and deeper bellhousing so anyone know if the PP is different for the 4 speed then with a 3 speed and I do not have another to compare it too and according to one parts stores website there is no difference.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode