06-30-2021, 11:37 AM | #1 |
Junior Member
Join Date: Jun 2021
Posts: 2
|
37 glovebox
1937 sedan glovebox spring reattachment, what’s the trick??
|
06-30-2021, 03:39 PM | #2 |
Senior Member
Join Date: Feb 2013
Location: Pittsford NY. USA
Posts: 1,097
|
Re: 37 glovebox
I didnt know there was a spring on it . Mine doesn't have one . Welcome to the Barn!
__________________
1952 Ford F1 1965 Ford Falcon Sprint 2007 Ford Mustang GT |
Sponsored Links (Register now to hide all advertisements) |
|
06-30-2021, 08:39 PM | #3 |
Senior Member
Join Date: Dec 2014
Location: Columbus, IN
Posts: 1,412
|
Re: 37 glovebox
There are two flat, semi-circular springs, about 3/4" wide, that hold the glove box lid closed on the 1937 Ford passenger cars.
I first install both springs in the two slots in the dashboard, then I used a piece of 12 ga. solid copper electrical wire to make a loop to pull the spring out to latch it on the door. Pull with one hand and push the spring over the lip with your thumb. Note, my pictures do not show the spring properly latched on the door. The spring when properly installed will be over the lowest rolled edge of the door. The spring won't have any tension if you put it in the wrong place. |
07-01-2021, 08:13 PM | #4 |
Junior Member
Join Date: Jun 2021
Posts: 2
|
Re: 37 glovebox
That looks like a winner and I'll try it in the morning. Thanks again
|
05-23-2024, 04:47 PM | #5 |
Member
Join Date: Jan 2012
Location: Idaho Falls, Id
Posts: 71
|
Re: 37 glovebox
What holds the door on to the dash? I see that the springs are available new, but I can not tell what secures the door to the dash.
|
05-23-2024, 07:37 PM | #6 |
Senior Member
Join Date: May 2010
Posts: 509
|
Re: 37 glovebox
Sponsored Links (Register now to hide all advertisements)
|
05-23-2024, 08:54 PM | #7 | |
Senior Member
Join Date: May 2015
Posts: 8,598
|
Re: 37 glovebox
Quote:
__________________
The only thing nice about being imperfect is the joy it brings to others.... "Silver rings, your butt! Them's washers!" "We shot our way out of that town for a dollar's worth of steel holes!" - from 'The Wild Bunch' - 1969 https://www.youtube.com/watch?v=7NReUd2_0u0 |
|
05-23-2024, 08:57 PM | #8 |
Senior Member
Join Date: May 2015
Posts: 8,598
|
Re: 37 glovebox
__________________
The only thing nice about being imperfect is the joy it brings to others.... "Silver rings, your butt! Them's washers!" "We shot our way out of that town for a dollar's worth of steel holes!" - from 'The Wild Bunch' - 1969 https://www.youtube.com/watch?v=7NReUd2_0u0 |
05-24-2024, 10:22 AM | #9 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 1,306
|
Re: 37 glovebox
If you find someone with the reproduction springs in stock, BUY THEM. The wholesale vendor (Vintique) has been out of stock for a couple of years.
|
05-24-2024, 11:20 AM | #10 |
Member
Join Date: Jan 2012
Location: Idaho Falls, Id
Posts: 71
|
Re: 37 glovebox
If there is a hinge mine must be separated from the door somehow, and last I looked there was nothing attached to the dash in the car still.
|
05-25-2024, 11:48 AM | #11 |
Senior Member
Join Date: May 2012
Location: Placerville, CA 95667
Posts: 100
|
Re: 37 glovebox
Here's a photo of my glove box and springs attached.
|
05-25-2024, 11:50 AM | #12 |
Senior Member
Join Date: May 2015
Posts: 8,598
|
Re: 37 glovebox
__________________
The only thing nice about being imperfect is the joy it brings to others.... "Silver rings, your butt! Them's washers!" "We shot our way out of that town for a dollar's worth of steel holes!" - from 'The Wild Bunch' - 1969 https://www.youtube.com/watch?v=7NReUd2_0u0 |
05-25-2024, 04:56 PM | #13 |
Senior Member
Join Date: May 2010
Location: Lexington, NC
Posts: 872
|
Re: 37 glovebox
There are three flathead screws with acorn nuts and I believe lock washers that attach the glove box door to the dash. You can see the acorn nuts in the picture in post #12. The cardboard finish piece is missing in the glove box door in this picture. It would have been covered in a material that was kin to headliner material. It may have even been the same material.
|
05-27-2024, 03:04 PM | #14 |
Member
Join Date: Jan 2012
Location: Idaho Falls, Id
Posts: 71
|
Re: 37 glovebox
Other than some pitting, I can't see where anything was ever attache at the bottom. I will have to check the dash again for hardware.
|
05-27-2024, 03:28 PM | #15 |
Senior Member
Join Date: May 2015
Posts: 8,598
|
Re: 37 glovebox
__________________
The only thing nice about being imperfect is the joy it brings to others.... "Silver rings, your butt! Them's washers!" "We shot our way out of that town for a dollar's worth of steel holes!" - from 'The Wild Bunch' - 1969 https://www.youtube.com/watch?v=7NReUd2_0u0 |
05-27-2024, 08:07 PM | #16 |
Senior Member
Join Date: May 2010
Location: Lexington, NC
Posts: 872
|
Re: 37 glovebox
That’s because your hinge has completely rusty off. You can see the ragged edge where it used to be.
|
05-30-2024, 12:15 PM | #17 |
Member
Join Date: Jan 2012
Location: Idaho Falls, Id
Posts: 71
|
Re: 37 glovebox
Looks like I will be doing some fabrication then with a piano hinge. I got the piece off of the dash and sand blasted it, and I can see better now where it clearly separated from the glove box door. It should be an easy fix where the door would hide the repair anyways.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|