Forum: Early V8 (1932-53)
05-29-2024, 10:25 PM
|
Replies: 14
Views: 337
|
Forum: Early V8 (1932-53)
05-28-2024, 09:27 PM
|
Replies: 15
Views: 552
Re: change to hydraulic brakes on a -36
Be aware you will also need to change your front hub/drums to '37-'39 parts if you are going to retain your wide 5 wheels. Your '36 rear drums will work.
As the previous poster stated you can make...
|
Forum: Early V8 (1932-53)
05-28-2024, 08:43 PM
|
Replies: 6
Views: 292
|
Forum: Early V8 (1932-53)
05-28-2024, 08:41 PM
|
Replies: 3
Views: 178
Re: '36 Back Roll-Down Window Install Questions
I won't say I'm an expert on this. The glass channel is one piece a big inverted U. I installed the channel, glass with lower track, and the regulator in one piece, then installed the regulator...
|
Forum: Early V8 (1932-53)
05-24-2024, 05:13 PM
|
Replies: 6
Views: 401
|
Forum: Early V8 (1932-53)
05-20-2024, 09:23 AM
|
Replies: 20
Views: 1,007
Re: Puttin a key in the drivers door
I think your parts problem revolves around the fact that the passenger door locks were below the handle; while the truck locks were above the handle.
You would need the pieces from a R/H passenger...
|
Forum: Early V8 (1932-53)
05-18-2024, 12:47 AM
|
Replies: 8
Views: 506
|
Forum: Early V8 (1932-53)
05-17-2024, 08:35 AM
|
Replies: 7
Views: 414
|
Forum: Early V8 (1932-53)
05-16-2024, 11:29 PM
|
Replies: 7
Views: 414
Re: 33 Fordoor windshield removal
Unhook the regulator either by removing the the two screws or driving out the pin. Take out the header panel and remove the two screws from each hinge then lift the bottom edge outward and the frame...
|
Forum: Early V8 (1932-53)
05-15-2024, 11:48 PM
|
Replies: 39
Views: 1,490
Re: Model B Ford 4 cylinder identification
Rear mounts can easily be added to the '32 rear mount plate or as DavidG mentioned a '33-'34 rear mount plate which has mount tabs can be used instead.
Setting it up with a clutch would prove more...
|
Forum: Early V8 (1932-53)
05-14-2024, 11:04 PM
|
Replies: 2
Views: 186
|
Forum: Early V8 (1932-53)
05-13-2024, 04:29 PM
|
Replies: 9
Views: 574
Re: 1934 Fordor roof
Last '33 we did the compressed paper was 80% gone so we removed the rest of it, then drilled the rivets and removed the thin metal channel that held the paper. It was in good shape so we had it...
|
Forum: Early V8 (1932-53)
05-11-2024, 12:09 AM
|
Replies: 55
Views: 2,688
Re: Hot rod steering box
Here's a picture of a F-100 box we put in a '32 that may help give you an idea of where it would live.
|
Forum: Early V8 (1932-53)
05-10-2024, 11:13 AM
|
Replies: 55
Views: 2,688
|
Forum: Early V8 (1932-53)
05-09-2024, 05:38 AM
|
Replies: 55
Views: 2,688
Re: Hot rod steering box
Looks like the F-100 box in your picture has had the output shaft cut square to fit a Model A pitman arm along with most of the flange cut away.
|
Forum: Early V8 (1932-53)
05-03-2024, 06:30 PM
|
Replies: 6
Views: 332
|
Forum: Early V8 (1932-53)
05-03-2024, 06:25 PM
|
Replies: 17
Views: 681
|
Forum: Early V8 (1932-53)
05-03-2024, 07:25 AM
|
Replies: 7
Views: 624
Re: sagging drivers door -1936 ford tudorsedan
Check the door gap on the A pillar, if it is uneven bend the hinges to correct.
If it is even, something else has sagged and you probably will need to shim the body to bring the back of the door...
|
Forum: Early V8 (1932-53)
05-03-2024, 07:08 AM
|
Replies: 17
Views: 681
Re: 1936 driver side door latch
Maybe a little clearer picture. The arrow points to the original ears that retain the spring. Many times these ears break off when spread to replace a broken spring. The piece that Deuce posted is a...
|
Forum: Early V8 (1932-53)
04-26-2024, 03:02 PM
|
Replies: 17
Views: 1,404
Re: Brake drum question
They do and at a better price than Eklers; but curious about where they come
from (Argentina?) and if they more accurately machined than the ones that
were available previously.
...
|
Forum: Early V8 (1932-53)
04-24-2024, 10:52 AM
|
Replies: 7
Views: 678
Re: Parking brake disassembly
Slide the handle off the pawl/mount, push the rod into the lever from the bottom, press the little pin that is now accessible out of the button, pull the rod and ratchet out of the lever, and finally...
|
Forum: Early V8 (1932-53)
04-16-2024, 06:48 PM
|
Replies: 9
Views: 819
|
Forum: Early V8 (1932-53)
04-16-2024, 06:42 PM
|
Replies: 23
Views: 1,519
|
Forum: Early V8 (1932-53)
04-16-2024, 08:40 AM
|
Replies: 23
Views: 1,519
|
Forum: Early V8 (1932-53)
04-14-2024, 09:51 PM
|
Replies: 19
Views: 992
Re: Directionals switch
From what you described; the power from the flasher isn't getting to the switch or there is a problem inside the switch.
I would remove it from the column, take it apart, and check the wire as...
|