|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-11-2024, 07:01 PM | #1 |
Junior Member
Join Date: Jun 2020
Posts: 4
|
Front Seat 1931 Sant Windshield Info Request
I am reupholstering the front seat of my 1931 Slant Window Model A On the inside of the sides the steel tub there are four rivets with slots on the floor of the tub. I imagine there should be a piece of wood covering the slots and held in place by the rivets. Is this correct? Any pictures would be very helpful...Thanks in advance mike m
|
04-12-2024, 01:14 PM | #2 |
Senior Member
Join Date: May 2010
Location: Concord CA
Posts: 639
|
Re: Front Seat 1931 Sant Windshield Info Request
Can these holes be used for the seat adjustment slides? Years ago, when I did mine, my seat adjuster slides where never removed from the bottom of the seat tub. Good luck maybe someone else will chime in.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-13-2024, 10:36 AM | #3 |
Junior Member
Join Date: Jun 2020
Posts: 4
|
Re: Front Seat 1931 Sant Windshield Info Request
Thanks Herb. I think the slots were used to tack the upholstery around the bottom of the seat. The rivets where there to hold a tacking strip in place on each side of the seat. Just my guess. Will see if I hear any other comments Thanks for you input
|
04-13-2024, 03:33 PM | #4 |
Senior Member
Join Date: May 2010
Location: Concord CA
Posts: 639
|
Re: Front Seat 1931 Sant Windshield Info Request
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|