Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-20-2019, 10:04 AM   #17
Terry, NJ
Senior Member
 
Terry, NJ's Avatar
 
Join Date: May 2010
Location: Bucks Co, Pa
Posts: 3,301
Default Re: OK! Oldtimers, Gimme your best answer, Stuck Engine

Yes! That exactly what I was told to do. Plus, the head was off and the water neck was off the block. I was able to heat the left side of the cylinders externally. ( inside the water jacket) Because the temperature was at freezing and the block was cold, so I was nervous about heating it in just one place (Actually 4) This method was recommended to me by an old timer, sadly, it did not work, this time! I might try again today (Weather reports are for 58 degrees) If I can't loosen the rings this way, It will point strongly to the bind being the bearings.
Wish me luck!
Terry



Quote:
Originally Posted by Railcarmover View Post
I like the 'heating of the cylinders'... what did you do?take a torch to the side of the block?amazing..
Terry, NJ is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:17 PM.