|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-18-2019, 02:36 PM | #21 |
Senior Member
Join Date: May 2010
Location: Southern Maine
Posts: 1,498
|
Re: H&H Model A motor thrust bearing issue
|
03-28-2019, 10:52 AM | #22 |
Member
Join Date: Jan 2012
Location: Southern California
Posts: 44
|
Re: H&H Model A motor thrust bearing issue
Benson, You are correct. The thrust 'washers' are really half washers that are on the bottom half 'Cap'. Although this is not ideal (Jim Brierly is correct) it does make it easier to replace without pulling the engine. With that said, I won't buy a H&H motor or have them rebuild one as I too prefer the thrust bearing the way 'Henry intended it'.
|
Sponsored Links (Register now to hide all advertisements) |
|
03-28-2019, 10:29 PM | #23 | |
Senior Member
Join Date: May 2010
Posts: 2,597
|
Re: H&H Model A motor thrust bearing issue
Thanks for response Edgar,
I saw one or two of these engines about 5 or 6 years ago, maybe longer than that, and wondered if they had a washer on the upper block side. I did not take one apart to see and always wondered how long it would last! Quote:
Last edited by Benson; 03-29-2019 at 10:03 AM. |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|