|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-31-2016, 10:17 AM | #1 |
Senior Member
Join Date: May 2010
Location: SPEEDWAY INDIANA
Posts: 4,148
|
Cant do this !! Helmet rebuild......
Guys took this one apart this morning , came apart nice ( too nice) . Was way over lubed ( greased) ya cant fill the rear with grease and expect the advance weights to come out with rpm.....
Light lube only !!! |
10-31-2016, 04:31 PM | #2 |
Senior Member
Join Date: May 2010
Location: FP, NJ
Posts: 2,770
|
Re: Cant do this !! Helmet rebuild......
I took a '48 rear end apart. I think they pumped grease into the fitting on the torque tube expecting it to come out of the air filter.
__________________
Don't never get rid of nuthin! |
Sponsored Links (Register now to hide all advertisements) |
|
11-01-2016, 01:17 PM | #3 |
Senior Member
Join Date: May 2010
Location: SPEEDWAY INDIANA
Posts: 4,148
|
Re: Cant do this !! Helmet rebuild......
The other side of the story ( reassembly after clean up). Dont know where i found this Ultra spray lube but have had the occasion to see a distributor up close after a couple years of hard driving and the inside still looks very nice with no rust etc....
|
11-01-2016, 07:49 PM | #4 |
Senior Member
Join Date: May 2010
Location: South Kingstown, R.I.
Posts: 262
|
Re: Cant do this !! Helmet rebuild......
Sponsored Links (Register now to hide all advertisements)
Regards, Don |
|
|
Sponsored Links (Register now to hide all advertisements) |
|