|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-18-2013, 03:54 PM | #1 |
Senior Member
Join Date: May 2010
Location: Delta, PA
Posts: 525
|
37-39 Headlight Gasket
Anyone know exactly where the gasket and retainer go on a 37 tudor headlight ? Does the gasket and retainer go around the bucket lip ? I will attempt to change my sealed beams back to the reflector and bulbs tomorrow, it may be straight forward when I have it opened up tomorrow, but nothing like knowing where it goes in advance. Thanks Zeke
__________________
Only problem with retirement is never a day off |
12-18-2013, 04:15 PM | #2 |
Senior Member
Join Date: Jun 2010
Location: West Hammond, Illinois
Posts: 2,793
|
Re: 37-39 Headlight Gasket
I used this drawing.
|
Sponsored Links (Register now to hide all advertisements) |
|
12-18-2013, 04:19 PM | #3 |
Senior Member
Join Date: Jun 2010
Location: West Hammond, Illinois
Posts: 2,793
|
Re: 37-39 Headlight Gasket
The thick rubber gasket/seal (13066) goes on the headlight bucket and the retainer (13067) goes around it and holds it on; the lense will set on this combine.
|
12-18-2013, 04:33 PM | #4 |
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,024
|
Re: 37-39 Headlight Gasket
Was the original gasket/seal (13066) made of rubber or cork? I see both are available.
|
12-18-2013, 04:43 PM | #5 |
MEMBER EMERITUS
Join Date: May 2010
Location: New Zealand
Posts: 1,380
|
Re: 37-39 Headlight Gasket
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|