06-05-2022, 08:33 AM | #1 |
Senior Member
Join Date: Apr 2011
Location: Plainview, Texas
Posts: 757
|
Zenith float
Was cleaning my carb yesterday and noticed the hinge tube on the float has broken loose, can it be repaired? It was running fine, maybe it just happened. Do I need to get another? Thanks
|
06-05-2022, 09:09 AM | #2 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,106
|
Re: Zenith float
A little solder - to hold will work
__________________
www.whidbeymodelaclub.com Last edited by Gary WA; 06-05-2022 at 11:29 AM. |
Sponsored Links (Register now to hide all advertisements) |
|
06-05-2022, 07:38 PM | #3 |
Senior Member
Join Date: Mar 2012
Location: Ohio
Posts: 1,977
|
Re: Zenith float
A helper on these little jobs sometimes is a big benefit.
|
06-06-2022, 03:13 AM | #4 |
Senior Member
Join Date: Jul 2010
Location: United Kingdom
Posts: 1,444
|
Re: Zenith float
I have notice some new repro ones are not soldered - just crimped
|
06-06-2022, 07:08 AM | #5 |
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,106
|
Re: Zenith float
Try to get the bracket exactly in the same position or you will not be able to get a good gas level adjustment. Use flux and lead based solder to keep the heat down. This is an easy repair. Ed
|
06-06-2022, 08:20 AM | #6 |
Senior Member
Join Date: Jun 2014
Location: Land of Lincoln
Posts: 3,131
|
Re: Zenith float
Sponsored Links (Register now to hide all advertisements)
__________________
Don't force it with a little hammer tap, tap, tap get a bigger hammer tap done |
|
|
Sponsored Links (Register now to hide all advertisements) |
|