06-08-2015, 04:42 PM | #1 |
Senior Member
Join Date: Oct 2013
Location: Lopez Island, Wa.
Posts: 276
|
head leak
I have new rebuilt engine with Snyders 5.5 head, not installed by me but the builder..I now have a small leak at rear of head and have torqued all studs to 55 pounds...question is when I replace head gasket should I take studs out and put thread sealant on them so no water comes up studs..I know the builder did not do this...I know it should have a B head gasket and I will use the copper spray before installing...
__________________
The only thing worth learning is what you learn after you know it all !! |
06-08-2015, 06:34 PM | #2 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,104
|
Re: head leak
Sponsored Links (Register now to hide all advertisements)
__________________
www.whidbeymodelaclub.com |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|