|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-29-2019, 11:45 PM | #13 |
Senior Member
Join Date: Feb 2019
Location: New Zealand
Posts: 208
|
Re: Bought three Flathead V8 engines yesterday
I have the truck block fully stripped. I turned up a tool on the lathe to remove and install the cam bearings. I have a question. I have removed the fuel pump pushrod and I will be using an electric pump so it will not be going back. I have read that the hole the pushrod goes through has to be plugged to maintain oil pressure... My question is about the sleeve I can see in the hole... Should I take that out also or just plug the top of the sleeve??
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|