pieced axle shaft
here is a new form of sustainability. One of the previous owners ruined the thread of the axle shaft on one side by improperly removing the hub. The lathe operator did a good job. The connector is a 5 mm precision cylinder tube 30cm long, shrunk onto the stub shafts. Drilled 8x diameter 12mm x 7mm deep crossed and spot welded. After welding 0,0059 height difference, reduced to 0,0012 under a hydraulik press. Important, don`t forget to put on the half carrier before shrink the tube
Last edited by Ford-A-baquet; 12-15-2019 at 03:52 PM.
|