|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-21-2021, 09:38 PM | #1 |
Senior Member
Join Date: Jan 2018
Posts: 413
|
Transmission part ID
I am going to build the three top loaders I have that are in pieces.
The first one is done. I acquired a load of NOS trans parts a while back and was looking at them today to grab the parts I need for the builds. I ran across a few of these and can't ID them. They are not like thrust washers. Any ideas ? Thank you. |
11-21-2021, 11:52 PM | #2 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: Transmission part ID
Plate, B-7129, goes at rear of early style cluster with spur cut 1st and rev gear teeth
__________________
Unfortunately, two half wits don't make a whole wit! Last edited by Brian; 11-21-2021 at 11:58 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
11-22-2021, 02:18 AM | #3 |
Senior Member
Join Date: May 2012
Location: Queensland, Australia
Posts: 10,372
|
Re: Transmission part ID
95476 asks what is this Transmission part ID ? |
11-22-2021, 06:45 AM | #4 |
Senior Member
Join Date: May 2010
Location: southeastern Michigan
Posts: 10,101
|
Re: Transmission part ID
Brian identified it correctly.
|
11-22-2021, 10:00 AM | #5 |
Senior Member
Join Date: Jan 2018
Posts: 413
|
Re: Transmission part ID
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|