|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-31-2022, 03:01 PM | #1 |
Senior Member
Join Date: May 2010
Location: Bowling Green, Ky.
Posts: 228
|
Pressure Plate release lever stiffness?
Guys just mounted 39 tranny to fresh rebuild 59A, Weber flywheel. Rebuilt 9" clutch, pressure plate and new throw out. Slid pipe over clutch shaft arm and push forward but pressure plate release levers didn't budge after throw out made contact. Might supposed to be that stiff? I didn't want to push hard enough to damage anything. Appreciate your thoughts. Don't want to install and have to jerk back out.
|
12-31-2022, 06:59 PM | #2 |
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,578
|
Re: Pressure Plate release lever stiffness?
I don't think it should be that hard to move. The fingers had to move as you tightened up the PP, can you watch thru the hole on top ?
|
Sponsored Links (Register now to hide all advertisements) |
|
12-31-2022, 07:14 PM | #3 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 5,966
|
Re: Pressure Plate release lever stiffness?
How much force are you generating to do the job?
|
12-31-2022, 07:15 PM | #4 |
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 8,756
|
Re: Pressure Plate release lever stiffness?
Correct 59A type pressure plate? Fingers not fouling the input or front snout?
Remove cover and have a good look. You need about a 2 ft long lever to do it without struggling. |
01-02-2023, 01:31 PM | #5 |
Senior Member
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,390
|
Re: Pressure Plate release lever stiffness?
Are the fingers adjusted properly??
Paul in CT |
01-02-2023, 04:21 PM | #6 |
Senior Member
Join Date: May 2010
Location: Bowling Green, Ky.
Posts: 228
|
Re: Pressure Plate release lever stiffness?
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|