|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Aug 2012
Location: Texas
Posts: 229
|
![]()
I have a new oil pump for my 29 and need to prime the pump. Which direction does the pump turn, clockwise or counter clockwise? I will immerse it in a can of oil and turn it with my drill to prime it enough to lube the gears. It might not be necessary but I will be more confident there will be oil on startup.
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Aug 2010
Location: SF Bay Area
Posts: 195
|
![]()
Counterclockwise looking from the shaft end- just like the distributor looking from the top.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: Aug 2012
Location: Texas
Posts: 229
|
![]()
Thanks, I will install my oil pan now.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Apr 2011
Location: Davenport, Iowa
Posts: 2,113
|
![]()
Be sure to place a small bucket or cup next to the hole where the oil squirts out so that you can catch the exiting oil. Otherwise, the pump will send a stream of oil halfway across the garage! MESSY!
Marshall |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Jan 2012
Location: Western North Carolina
Posts: 3,904
|
![]()
To prime the engine you can pour the last quart down the hole that the distributor goes in.
__________________
A is for apple, green as the sky. Step on the gas, for tomorrow I die. Forget the brakes, they really don't work. The clutch always sticks, and starts with a jerk. My car grows red hair, and flies through the air. Driving's a blast, a blast from the past. |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Aug 2012
Location: Texas
Posts: 229
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
#7 | |
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,849
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#8 |
Senior Member
Join Date: Dec 2013
Location: Waxahachie, Texas
Posts: 950
|
![]()
oldspert,
As nkaminar says, I highly recommend pulling the distributor and pouring at least 2 quarts of oil down the hole to help prime the pump and flood the lifter gallery and upper main bearing oil supply. Everything gets a good baptism in fresh oil. Nothing is disturbed by pulling the distributor and it is easy to slip back in place - your timing and point gap are not affected in any way. (Let me know if you need help. Your friend down the road in Waxahachie! ![]() |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|