|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-09-2012, 03:27 PM | #1 |
Junior Member
Join Date: May 2012
Posts: 12
|
1956 ford fairlane
City:
seneca falls
State:
ny
i am parting out a 2 door club sedan. a lot of good parts. will be listing stuff on ebay s will be in carlisle at all ford meet with parts,
Last edited by 0668ed; 05-09-2012 at 04:03 PM. |
06-17-2012, 01:29 PM | #2 |
Junior Member
Join Date: Jun 2012
Posts: 2
|
Re: 1956 ford fairlane
Hi- I am needing rear end (differential ass'y) 3.22 for 56 fairlane hdtp. w/Fordo. would your unit be of this type? Have you ever driven this car to know anything of condition. thank you. Kurt K
|
Sponsored Links (Register now to hide all advertisements) |
|
07-07-2012, 11:24 PM | #3 |
Junior Member
Join Date: Jul 2012
Location: St. Louis Mo
Posts: 2
|
Re: 1956 ford fairlane
Hi, I looking for intake and exhaust manifolds for a ford 233 6 cylinder.
Thanks |
10-22-2012, 09:13 PM | #4 |
Junior Member
Join Date: Jul 2012
Posts: 24
|
Re: 1956 ford fairlane
Hi,
I am looking for interior door trim for a 1956 Ford Parklane. It is a 2 door; there is a trim piece (sort of u-shaped) above the arm rest and a trim plate across the bottom of the door. Thanks, Mike |
10-23-2012, 08:35 PM | #5 | |
Senior Member
Join Date: May 2010
Location: St.Thomas, ON Canada
Posts: 598
|
Re: 1956 ford fairlane
Sponsored Links (Register now to hide all advertisements)
Quote:
Mike, don't foget that the Parklane has a different arm rest than the Victoria, but I think its the same as the Crown vic.
__________________
If brains were wire, some couldn't short circuit a firefly |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|