The Ford Barn

Mike/Nebraska · 04-14-2017, 04:45 PM

I have a Model b head (C) that I want to use on my Model A. Does anyone know the compression ratio of that head? Also can I get by with a copper headgasket ith that head? thanks, Mike

Bob C · 04-14-2017, 04:57 PM

According to Vince's site 4.6 : 1. http://www.fordgarage.com/pages/head...ssionratio.htm

Bob

Tom Wesenberg · 04-14-2017, 06:15 PM

Sponsored Links (Register now to hide all advertisements)

Copper is the only head gasket I use. With Copper Coat sprayed on both sides of course.
Right now my 28 is using a very old used head gasket that I cleaned up and reinstalled. It's working fine.

04-14-2017, 04:45 PM	#1
Mike/Nebraska Senior Member Join Date: May 2010 Location: Eastern, Nebraska Posts: 354	compression ratio I have a Model b head (C) that I want to use on my Model A. Does anyone know the compression ratio of that head? Also can I get by with a copper headgasket ith that head? thanks, Mike

04-14-2017, 04:57 PM	#2
Bob C Senior Member Join Date: May 2010 Location: So Cal Posts: 8,754	Re: compression ratio According to Vince's site 4.6 : 1. http://www.fordgarage.com/pages/head...ssionratio.htm Bob

04-14-2017, 06:15 PM	#3
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: compression ratio Sponsored Links (Register now to hide all advertisements) Copper is the only head gasket I use. With Copper Coat sprayed on both sides of course. Right now my 28 is using a very old used head gasket that I cleaned up and reinstalled. It's working fine.