10-30-2020, 08:12 AM | #1 |
Senior Member
Join Date: Mar 2014
Location: Jacksonville FL
Posts: 3,961
|
Anyone know?
Here at work and need to grab a couple machine screws...ANYONE know the size and length of the Round Head Machine Screws that hold the coil to the Distributor Late 36 to 41???? Thanks
|
10-30-2020, 08:46 AM | #2 |
Senior Member
Join Date: Sep 2013
Location: Dighton, Mass
Posts: 1,230
|
Re: Anyone know?
although I know what they look like but I would keep sticking drills in the housing just
until it fits not loose but just snugg. that would be close to the major diameter, then go on line for machine screw charts. I think these screws are 1/2 long and I think fine thread around a No. 8. The easy way, take the distributor and coil to the hardware store the screw is common they will fix you up. And please buy stainless and buy more than you need because you drop one screw goes to that dreaded hole in the floor gone: sam |
Sponsored Links (Register now to hide all advertisements) |
|
10-30-2020, 08:59 AM | #3 |
Senior Member
Join Date: Mar 2014
Location: Jacksonville FL
Posts: 3,961
|
Re: Anyone know?
I think its like 8/32 X 1-3/4 "ish" but was looking for "fact" or confirmation!!
|
10-30-2020, 09:07 AM | #4 |
Senior Member
Join Date: May 2010
Location: Southern Illinois
Posts: 3,795
|
Re: Anyone know?
I'd contact Michael Driskell at Third Gen Automotive. The Ford Bolt business he bought from Roy is impressive. As is his knowledge of fasteners.
|
10-30-2020, 09:09 AM | #5 |
Senior Member
Join Date: Feb 2011
Posts: 2,113
|
Re: Anyone know?
I couldn’t remember so I looked it up.....See attached 27177-S7
__________________
Tim Downtown, Ca |
10-30-2020, 09:13 AM | #6 |
Senior Member
Join Date: Dec 2014
Location: Columbus, IN
Posts: 1,407
|
Re: Anyone know?
Sponsored Links (Register now to hide all advertisements)
|
10-30-2020, 12:38 PM | #7 |
Senior Member
Join Date: May 2010
Location: Florida and Penna.
Posts: 4,471
|
Re: Anyone know?
10-32 sounds more like it to me. G.M.
__________________
www.fordcollector.com |
10-31-2020, 06:30 AM | #8 |
Senior Member
Join Date: May 2010
Location: Meredith, N.H.
Posts: 766
|
Re: Anyone know?
That would be correct
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|